markagrip Printed Hazard Anti slip tape
- Ex Tax: £3.44
Our markagrip Printed Hazard Anti Slip Tape allows you to highlight areas of your workplace that are particularly hazardous. It has a printed, anti-slip surface with a mineral coating for heightened strength. This minimises the risk of slipping or trips while offering exceptional grip. The smooth finish ensures it won't become clogged up with dirt, dust or other contaminants - the perfect solution for food preparation areas or those with stringent hygiene requirements. With its self-adhesive backing, this tape can be fitted and applied in minutes to bring your work up to health and safety standards.
It has a strong and durable construction that is not readily affected by chemicals. This tape can be applied to almost any surface, both inside and outside and including porous surfaces such as wood, concrete or stone. For exceptional versatility, this ensures it is suited to all manner of applications and varied work environments too. Wherever is becomes vital to mark out a hazardous area, strips can be cut to size and applied swiftly to protect the safety and reduce the risk of injury to all.
Here at Quantick Safety Systems, we work hard to manufacture and source the best products for all your floor safety needs. This tape is one of our most versatile options and one that can be tailored to suit the requirements of specific businesses. If you have any questions about the markagrip Printed Hazard Anti Slip tape, get in touch with the team here today.
Variants: 75 mm x 18.3 m roll with 'ATTENTION DANGER' printed on the surface or 150 mm x 610 mm Cleats with either 'CAUTION' or 'WATCH YOUR STEP' printed on the surface. Sold as either 1 Roll or 1 Cleat dependant on choice.
For more information on markagrip or for a quote or sample, fill out the request a quote/sample or contact us from and we will get back to you ASAP.
For ensuring the best results and maximum life span of your markagrip the below instructions should be followed.
Your printed markagrip should be stored in a warm, dry conditions in the original protective packaging to prolong its lifespan
Ensure the surface is clean and dry. Ideally an IPA cleaner should be used to remove all surface contaminants such as paint flakes and grease. The application surface must be above 10°C.
3. Surface Sealing
Any porous surfaces should be sealed prior to application to prevent water attacking the adhesive. Ideally you should apply Toluene based primers. Apply a thin coat to the clean surface using a paint brush and then leave to dry
4. markagrip Application
Peel back part of the release liner and then press firmly onto the prepared surface, gradually peeling back the liner as you apply the tape. Make sure that the tape is not too taut.
Once the tape has been applied, press the tape down firmly using even pressure (a decorating roller is perfect for this task). The edges should be sealed using the edge fix to extend the lifespan of the product. A small amount should be applied in a thin bead along the edges of the tape and allow to dry. If it has been correctly applied and edge fix has not been used, the new anti-slip surface can be walked on immediately, but you will achieve maximum benefit from the adhesive system after 48 hours.